AA Battery holder for 16 cells

This is a simple 16-cell AA battery holder, created with TinkerCAD (search for “AA-Battery-Holder-16-Upright”). I needed something to organize my rechargeable NiMH batteries while topping them off in the recharger 8 cells at a time. It's probably not too strong so don't stress or twist it too much, but it does seem to have good structural integrity.

I printed at 0.2mm, 20% fill, no brim or supports required. 0.3 draft mode probably would be fine as well, and shaves an hour off the print time.