Roly-Poly Marshmallow Man

This is a self-righting toy marshmallow man that gets up when pushed down.

Print settings: 

• Filament: PLA
• Layer height: 0.2mm
• Infill: 10%
• Supports: Yes
• Perimeters: 2
• Seam position: Rear

To assemble you need:

• M20 Nut

Notes:

• I confirmed works fine with scale factors 120% M24 nut and 80% M14 nut.
• Too much infill will raise the center of gravity and may interfere with getting up.

Assembly: 

1. Set the nut on the top part and screw in the bottom part to secure it.
2. Glue the hat to the head.

My Other Balancing Toy:

Roly-Poly Snowman - https://www.printables.com/model/335013-roly-poly-snowman

Modern Design Yajirobe - https://www.printables.com/model/259592-modern-design-yajirobe

other version