P2Pouch - Palette 2 Pouch For Upside Down Wall Mounting

I needed a way to mount my Palette 2 Pro upside down on the wall underneath my RepBox, but the stock wall mount was only made for usage right side up. So off to Fusion360 I went...

This is a LONG print. Recommend using at least 3 perimeters and 25% or more infill with PETG, ABS/ASA or Nylon.

Designed to with 6 holes for mounting. Be sure to use appropriate drywall anchors, as you don't want your expensive new toy falling off the wall...

The holes on the sides allow for connection of USB and power, as well as venting air. Be sure to flip the screen in the units setup.

Should fit both Pallete 2 and Pro.

Edit: 2019 March 01: Joe Mike did a great alternate version of this that is a 2 piece design that is much easier to print. Check it out here:
https://www.thingiverse.com/thing:3458317