Leveling feet for a Christmas tree stand. The overall collapsed size is 48mm outside diameter x 37mm tall. Maximum height adjustment is approximately 12mm or 1/2". The male threaded part is provided with either a 3/4" (19.1mm) or 1" (25.4mm) hole x 3/4" (19mm) deep. The 3/4" diameter hole suits the feet on our pre-lit CANVAS/Noma tree stand. The leveling feet will lift the tree approximately 1" (25mm). The 48mm OD matches the diameter of large self adhesive felts to protect wood floors.
Fit may be a little tight initially but will thread in and out freely after a few uses. Lightly sand the outside diameter of the male thread to help with a smooth fit if needed.
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
50%
Notes:
Recommend printing solid (100% infill) for maximum strength.
Category: HouseholdThe author marked this model as their own original creation. Imported from Thingiverse.