Logitech TAP wall mount bracket

Logitech charges about $150 for the metal wall mount plate for the Logitech TAP tablet for Teams Rooms. We couldn't wait that long so I designed one and its so good we're using them all around our buildings now (10 units). This alone paid for our Prusa mk3s that I pushed my employer to purchase. Score!

Large opening for cables to be run through the walls, small channels for cables if you do wall conduit instead. 4 screw holes for screwed wallmounts. The holes line up perfectly with the Tap device and use the included screws in the rubber holder. 

I print without supports and the unsupported screw area requires a tiny bit of cleanup with tweezers/cutters but it prints ina bout 1:47 with no supports, 20% grid infill with a 0.4mm nozzle at .3mm layer height. 

I made a different design for the remote holder, which uses some speed tape as the motion sensor is at the TOP of this tablet so I needed to redirect it to face into the room. (Silly design on Logitech's part) 

Picture is of finished setup - But you can't see this part, because its stealth behind the unit!