5" touchscreen Raspberrryry PI LCD Bezil with Taz 3 control box cover

This is a set of mounting hinges, LCD container boxes, and associated bracketry for installing a 5 inch HDMI touchscreen for Raspberry Pi in the dead space in front of the Lulabot Taz 3 (or 4/5 with a bit of modificiation) control box. This will allow you to make your printer look cooler, and be more functional at the same time, which is a win! This uses several M3 heat set inserts, 2 M3 10mm bolts, 10 M3 6mm bolts, 4 M3 12 or 14mm bolts, a really long ribbon cable (26 pin, prefferably mail one end and female the other, though those seem to be very rare) and ribbon hdmi calbe for Raspbery Pi .

Print instructions

Unassociated tags: touch screen

Category: 3D Printer Parts Summary

This is a set of mounting hinges, LCD container boxes, and associated bracketry for installing a 5 inch HDMI touchscreen for Raspberry Pi in the dead space in front of the Lulabot Taz 3 (or 4/5 with a bit of modificiation) control box. This will allow you to make your printer look cooler, and be more functional at the same time, which is a win! This uses several M3 heat set inserts, 2 M3 10mm bolts, 10 M3 6mm bolts, 4 M3 12 or 14mm bolts, a really long ribbon cable (26 pin, prefferably mail one end and female the other, though those seem to be very rare) and ribbon hdmi calbe for Raspbery Pi .

Print Settings

Printer Brand: LulzBot

Printer: TAZ 5

Rafts: No

Supports: No

Resolution: 0.5mm

Infill: 85% or better

Notes:

Printed with ABS, PLA or other plastics would work well. Support is already integrated into the model.

Post-Printing

Instructions.

Print out the things. Install 8 M3 heat set inserts in the front LCD bezil, 2 in the rear box cover, 2 in whichever LCD bracket hinge thing gets them installed in the ends, and 2 n the Taz 3 control box cover (or adapt this to fit on anyother control box - If there is interest I'll make a 4/5 specific variant that will fit. )

Then bolt everything together, feed the wires through where they need to go, and you should be all set. I'm not listing a wire source at this time, because I am looking for better variants of both wires.