Lots of Snowflakes inside a bauble (Christmas tree ornament)

https://www.buymeacoffee.com/maxt

----------------------

2mm thick

The best quality is achieved if printed face down

Print: 0.2mm
Nozzle: 0.4mm
Support: Not needed
Brim: Not needed
Infill: Not needed, but I'd suggest going with 100% to ensure sturdiness

A tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :)


 

Happy Printing!

--------------

https://www.buymeacoffee.com/maxt