Heated bed Cable pinch prevention retrofit clip for AO-10x series printers, Mendelmax, and possibly the TAZ

This is a retrofit clip designed to slide onto a 3mm thick aluminum heated bed retention plate, which will raise your heated bed cable up enough to eliminate the risk of pinching it at full Y extension. It should slide onto the heated bed retention plate, and then is held in place by a zip tie on the cable itself.

Print instructions

Category: 3D Printer Parts Summary

This is a retrofit clip designed to slide onto a 3mm thick aluminum heated bed retention plate, which will raise your heated bed cable up enough to eliminate the risk of pinching it at full Y extension. It should slide onto the heated bed retention plate, and then is held in place by a zip tie on the cable itself.

Instructions

Print it out, find a zip tie that fits. Tested in ABS with a .5mm nozzle. You may need to use support to print the cable channel.