I printed the peg spring version, the black is PETG, the red is ASA. Looks good, but besides that....:( I had to clean all the screw holes otherwise the screws.do not pass through. This is ok, but instead the holes for the PTFE tube are a bit oversized :O Fitting the peg spring inside was a pain, but I managed. Screwed everything together just to notice that it doesn't work :( The same as the other comments, the blade doesn't go all the way up, because the spring is constrained. Also, I used 20mm screws, which are too long. And the 16mm are too short.
I printed the peg spring version, the black is PETG, the red is ASA. Looks good, but besides that....:( I had to clean all the screw holes otherwise the screws.do not pass through. This is ok, but instead the holes for the PTFE tube are a bit oversized :O
Fitting the peg spring inside was a pain, but I managed. Screwed everything together just to notice that it doesn't work :( The same as the other comments, the blade doesn't go all the way up, because the spring is constrained.
Also, I used 20mm screws, which are too long. And the 16mm are too short.