Customizable text box III

Have a rounded box for your stuff - now the box itself says what's inside.
Use OpenSCAD to adapt the text and sizes as needed. 

You can print the box without supports: 
This version III now allows to enter the angle at which the box sweeps upwards from the print bed. By default its 55 degree, so it should print fine without supports on most printers. If you choose an angle of 90 degrees, its like the version II, harder to print, but a bit bubblier.
Note that the wiggle room between the top lid and the bottom container is by default zero. If your printer is not well calibrated, increase this value to e.g. .3mm, so the lid fits on the bottom container.

If you print the top lid separately and stop the print at .85mm and change the filament color, you will have the text on top nicely readable. (As in the pictures posted above)

Have fun!

Other models:

If you like it, please have a look at all my customizable creations. There are configurable-text-based creations, multi-line label, gadget display stand, sweeping name plate, bunting banner, customizable text box III, pyramid text, name plate, Customizable text box with lid and round text. Have also a look at my configurable pack of dogs, rabbits, reindeers and santas. There are also useful coat hangers and finger toys.
Or just check out all my creations.