DWV PVC Pipe to 4" Hose

NOTE: This part is superseded by an updated adapter that prints as a single piece. I do not recommend you use this one for future needs. It works fine, but it's a pain to epoxy together.

Two part adapter to convert DWV PVC Pipe to 4" Flexible Dust Collection Hose. Comparable to WoodRiver's part #151295. Parts must be glued or epoxied together.

https://www.woodcraft.com/products/dwv-pvc-pipe-to-4-inch-hose-dust-collection-adapter-fitting

Print instructions

Print with 0.3mm layer height, no supports needed. Approximately 3.5 hours to print both parts at the same time.