Side rails for AnyTone AT-D578UV, and Yaesu FTM-400 (probably FTM-100)

Side rails for AnyTone AT-D578UV, and Yaesu FTM-400 (probably also FTM-100)

Do not use too long of screws, or you may damage or destroy your radio! 

Side rails are 8mm thick. Rails are tall enough to leave an air gap under the radio. I left space in the front to access the USB port for programming.

Printed with PETG, 20% infill, on Prusa MK2.

Used 4mm socket head cap screws to attach to radio. Make sure that the screws are not too long, or they can damage the radio!

These are small enough to print both side rails at the same time on my Prusa Original i3 MK2.

Print Settings

Printer Brand:

Prusa

Printer: 

Prusa Mk2

Rafts:

No

Supports: 

No

Resolution:

0.20

Infill: 

25%

Filament: KVP PETG Yellow

Notes:

Was surprised to find that this side rail also fits my Yaesu FTM-400DX. It probably also fits the FTM-100D as well

Category: Electronics