Napa 23003 Transferflow Trax II Filter Mount

Designed to print in TPU (I used Overture 95A Red).

Fuel Filter mount for an Older Trax 2 Transferflow tank, did not originally come with a filter but was added due to the stock pump failing and the newer systems using filters. If you use this to add a filter your original protective cover will no longer fit.

My old Fuel Pump died so I had to replace it with a Herko RV002, apart from splicing connectors I needed the following to restore my system:

• 3/8 Fuel Hose (between filter & pump)
• Stainless Steel 1/8" NPT threaded ¼" Hose Barb for pump
• 2x Stainless Steel Hose Barb Reducer 3/8" to ¼": one for the pump-to-filter, another for the pump-to-tank as the embedded connector for the RV002 is ¼".
• Short lengths of ¼" fuel hose to clamp the barb reducers into to step up hose sizes.
• Hose clamps
• The original nuts for the studs to mount.

Flow is great, the pump will kick on and move a few gallons in maybe a minute, when my pump was failing it would turn on and stay on for about 10 minutes and do that a few times before giving a NOFLOW code.