4pin Molex Connector to 3 pin JST-XH Female

I didnt have any crimpers for jst connectors so instead I made this so i could plug in a superPinda into my SKR pico without spending money on a crimper kit.

How to use:

first extract the 3 pins from the (50-57-9404) molex connector on your superPinda (will still work with an older Pinda with 4 pins, the thermistor is not used anyways) by using a needle nose plier by pushing the pins down and pulling them out at the same time

Insert in the order that your board uses (for my case it was black, blue, orange looking where the pins are visible)

Print settings

0.12 layer height

no supports

I printed mine in Overture Orange PETG at 255C with part cooling fan at 30%