A little clip that holds the extruder ribbon cable in place. Designed to reduce stress on the X motor wires. No screws or tools needed.
90-degree version is best for keeping cable tucked in close to printer, original version is best for minimizing cable stress.
Rafts:
No
Supports:
Yes
Resolution:
.28 x .5
Infill:
0%
Break off support.
When installing, be careful to avoid pinching any wires!
Remix off https://www.thingiverse.com/thing:5244810
The author marked this model as their own original creation. Imported from Thingiverse.