Nice Design, but the hinge ist a little to weak, and the printing Takes ro much support.
Simple Pokeball
Just a simple 4 part print with hinge at the back sized for a M3 x 20mm .
Might need glue depending on tolerance.
10
105
2
637
updated November 29, 2022
Makes
Comments
@onkelattu_137732 Sorry for the super late reply but the only part that I used supports on was the middle black section bridging works for the top/bottom centers and the hinge was set up for it being a display that uses a 3mm screw. If you would like to change the hinge download the [Pokeball unmerged.3mf] and you can make any adjustments you'd like.
I was not able to adjust it, without breaking it. Printed the Ring 3 Times. But a nice idea.
@HS_226362 what do you mean by adjusting? Your picture looks like it printed correctly you just put a 3mm screw through the hinge on the back(if the screw is breaking it you might need to turned down your extrusion rate to 90-95%. Its set up as a desk ornament(I've printed a couple as gifts that function fine). If you want to modify it to work better for what you want to use it for, like make the hinge bigger or something along those lines the unmerged file will let you do that. If you have any other questions feel free to pm me or reply to this.