Cable Clips, Cable and Tubes Management

I decided to design a simple cable clips because I did not like much the comercial ones, and they are very difficult to find in the area I live. And they are even cheaper at least for me.

Characteristics:

• They have an hexagonal shape so they can be aligned better that the square or round ones.
• The cable tie can be inserted from the top or from the side instead of only from the side on comercial version.
• They can be sticked with double side tape, glue, hot glue, etc.
• They can NOT be installed with screw :-(
• Two different sizes (Small, Big).
• Admits different sizes of cable ties.
• Very easy to print, big adhesion surface and no supports needed.
• Can be printed on any material that meet your needs.
• Many units can be printed in one go.
• Price per printed unit: 0.1-0.2€/$ or less depending on material and size.
• Posible to customize at Onshape, here is the link: https://cad.onshape.com/documents/095849beec4caedf25f2f278/w/3aba416b7ede97c91c66ba40/e/83df1d800544f6f76c65881a

Print instructions

Print recommendations:

• 0.4mm Nozzle
• 0.2mm Layer high
• 0.5-0.6mm Extrusion width
• No brim or raft.
• No supports