Stability Feet for 'Prusa Steel Sheet Holder' +V2

This is an addition to the 'Prusa Steel Sheet Holder 2er, 3er and 4er' to improve stability.

Problem: the surface area of the 2 slot version of the sheet holder is small and the sheets are tall, this causes the holder to fall on the side if hit.

Solution: these two feet help to improve the stability increasing the surface area, extending it to both sides.

2021 Update - 2er Feet V2

Improved model for the 2 slot version.

• Reduced tolerances for the hexagonal pins to improve the snap-fit
• Extended the surface area up to the external sides to avoid the bending of the sheet holder and improve the stability
• Nicer seamless line between the sheet older and the table
• Added .3mf file

2021 Mini extension (+2 mini's sheets)+ stability feet

• Mini sheetholder + stability feet

Print instructions

-Gyroid Infill 20% min. recommended.
-3 Perimeters
-PLA or PETG, print with the same material of the sheet holder.
-Print x2 pieces min.

The .gcode contains 2 feet already, in case you pick the stl file print two pieces then