This was designed to hold a brush along with the jar of shaving soap (Mitchell's).
I've provided a sketch of the sizes so you can check if they'll fit your kit.
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10-20%
Notes:
Print with the ring on the bottom, the post pointing up. In other words, print in its orientation it will be used.
The arms should be printed with the rounded edges on top.
The "arms" needs to be connected to the base via the tab. You will likely need to shave down the tab or the slot -- super glue may also be required.
Category: BathroomThe author marked this model as their own original creation. Imported from Thingiverse.