Just a test of settings. Thank you for this model
Quick bridging test
Just a quick test (about 1 hour) for testing the bridging capability of your FDM printer and its settings.
43
1577
16
4974
updated
June 3, 2020
Makes
Comments
Super useful print. Going to be helpful as I dial in some settings to try and improve my bridging :)
Does anyone have any advice on preventing sagging or stopping the nozzle from pushing down on the bridges? I'm printing ASA at 260c with max fans 200mm/s default bridge speeds (slow)
@3DPHUB I find that the filament droops and the pulls tight again if you do 0.8 flow for the first layer. As to how to prevent the next layer from remelting it and causing droop, I am still not too sure, but I am sure going faster is better here to to give enough time for the nozzle to remelt the bridge.
Printed a handful of these to help dial in my bridging settings for a couple different materials. Vey helpful.
Quick little test, showed some interesting results. The right wall was pulled to the left by the cooling filament
