Bezel and Mount for Uctronics 5 inch HDMI touch display

Bezel and mount for the Uctronics 5-inch HDMI and USB touch display for use on a Voron 2.4 or other 3D printers. 

Because of my choice to use the CB1 instead of a Pi in my recent printer build I was not able to use a DSI/CSI port for the touchscreen connection. I couldn't find a display with ports on the back. They all have edge connectors. This was the only display that had a rear-facing HDMI. I needed to build a bezel fat enough to hide the USB edge connector and cable on the side that would also accommodate the display mounting screws. 

UCtronics 5-inch display: https://amz.run/6ALz

Cablecc down angled 90-degree USB cable: https://amz.run/6AM0

The skirt mount is from sttts and not modified by me and only included for the sake of completeness. You can find the orignial skirt mounting bracket on their github: https://bit.ly/3u3gfkg

Use heat inserts in the 5mm holes for the display screws and the mounting brace. 10mm M3 screws will mount the brace securely in place.