Voron 2.4r2 PG7 Cable Gland and Endstop

This is a remix of jphalip's Voron 2.4 A Drive PG7 umbilical mount, which was a remix of Hartk's PG7 mount. The endstop carrier in jphalip's model was from Minsekt. 

In this version the PG7 hole location has moved slightly to be centered over the opening in the original A motor mount. The height of the adapter has been increased to fully seat the M3 SHCS so that the heads aren't protruding when fully tightened. The perimeter was adjusted for a closer fit around the endstop carrier. Rounds and chamfers were added for an appearance more consistent with the Voron Aesthetic. 

On the Y endstop mount there was some funky geometry on one side. That has been cleaned up. The slots were also modified for bridging.

Requires QTY 2 M3x35mm SHCS and QTY 2 M3x8mm SHCS

I am currently in the process of building a 2.4 with these parts. They have not yet been tested!