Engineer Castle (Plain)

UPDATE:  03/31/2023 - Model was revised at all three caps of the castle to print as connected and not pull off.

----------------------------------------------------------------------------------------------------------------

Made this for my military Engineers out there but for all to use and enjoy.  Just made it plain but will make a more detail version in the future.

It's small enough to print on an Ender 3 with good detail (See Pictures).

While you could print it laying down on its back, it was designed upright IOT print decently without any supports required if you apply your slicer settings appropriately and your 3D printer is tuned properly!

Hats Off to the Engineer Crew that continue to build through rain, sleet and snow!