Space Needle Bookmark

A thin simple bookmark in 3 varieties:

1. Multi-color – 2 colors on top and bottom.
2. Layered multi-color – 2 colors on top
3. Simple - 1 color

Designed with a .2mm layer height in mind.

For multicolor I don't have a multi-color printer, but with a little effort you can achieve the same result by doing some minimal color changes. I followed the guide from this pi case, with one important addition… In Printer Settings, for each Extruder, set Retraction Length when tool is disabled to 0. Otherwise you get a big blob when the new color starts.

Design notes:

I found that by making 1 layer of the white go all the way through even the black parts, it adds strength to not snap off between colors.

These are a bit large. You might decrease the size by 80% or more.