Aluminum Angle Light Rail

My work area did not have sufficient light. I saw I had a length of ¾" x 1/16" aluminum angle in the garage. So on to TinkerCad, I went! 

There are 3 brackets. For 5' lengths and under, you only need #1 and #2. For anything over 5', add a support bracket in the center. The brackets have a hole for an M3 screw if you are going to rotate the light much. You can drill the angle, or just snug the screw against it. All brackets were printed with petg, with draft layer height (0.3 for 0.4 nozzles or 0.4 for 0.6 nozzles). There are holes in the ends to run your power wire through. 1 strip of LEDs was run down one side and wrapped around the other. 

I also made a “diffuser” in case someone wants it. Use white or clear petg with a 5mm brim to help hold it to the bed.