Customizable Snow Globe - Ornament Edition

Looking for the original tabletop version? Check it out here!

An updated version of my snow globe model, now with the option for adding a ribbon loop! Scaled down to about 70% of the original design to fit on a tree easier.

Create your own snow globe by picking which panes to print and slotting them into the base! The base can support up to 3 panes at a time. A full snow globe can be printed/assembled in ~2.5 hours. I'd recommend selecting your middle pane in the ‘loop’ version if you intend on hanging it.

ASSEMBLY:
Print 1x Snowglobe_Base and 3x panes of your choice. Slot panes into the corresponding spots on the base. Depending on the tolerances of your printer you will likely need to glue in the panes with glue to hold them into the base. There are now slots in the bottom for easier gluing. Best results come from printing/painting panes in different colors to create a layered effect.

TROUBLESHOOTING:
If the fit is tight you can try filing/deburring the sides of the tab to make it slide in easier, if the panes are too thick you can either clear out the slots in the base using the same method or scale the Z slightly down. I adjusted my Z height partway through printing these and noticed my parts didn’t want to fit anymore, so it might be an option for you as well.

Thank you all for all of your support on my previous design, I hope you enjoy this one as well :)

-Allison, Sconnie Makes