Delta-P fan duct V2R2.2-duct X2-Endoscope
I made this remix to fit a 7mm camera module while still keeping the two LED's at the sides.
30
118
3
1116
updated December 24, 2022
Description
PDFYou can read my full guide on how to make this and set it up over at Instructables. Made for 7mm camera modules (some filing might me needed to get a snug fit)
Print in PETG, 0.2mm layer height.
If you make this, I would love to see how your view turn out!
Installation Instructions by @teookie, presented here only for your convenience:
Note that these steps show @teookie's geometry (not my remixed geometry)
If you are still reading this, congratulations, you are serious about 3D printing!
Happy printing!
Model origin
The author remixed this model.
