Fantastic design, prints so efficiently in vase mode!
Mine was leaking at the base, I think because I enabled the 'Smooth spiral' setting. Lucky for me it's ABS, so I poured in a tiny bit of acetone, swirled it around, and let it dry. Now it's water tight!
Very nice. Thanks for sharing. Happy to read it works with ABS as well. 🙂
Cheers 🌷
@ZS_Design awesome.
Thanks for sharing.
Cheers
It survived the waterproof test.
Printed in bavaria filaments PLA metallic with a line width of 0.53mm
@LowRunneR happy to hear. Classy color choice.
Cheers
@NotReallyLex awesome. Thanks for sharing.
Cheers
@Verender wow, did you do the filament switch on the fly?
Cheers
@nilson_fx Yes because i was running out xD
Simple but cool, and surprisingly strong design. I did PETG @ 0.8mm walls(out of a 0.4 nozzle).
Shortened up the bottom to reduce print time.
Sealed the inside with wipe on polyurethane to ensure water tight, they work good!
@AkAdventurer looking great. Thanks for sharing 🙂
Cheers
@Verender looks great. Thanks for sharing your make 👍
printed in VM mode, took bit more than 2 hours (I played with printer speed and was printing on 150% most of the time). It holds water and does its job quite well :)
@GeorgsSpolis_380131 looks great in yellow. Thanks for sharing.
Cheers
It's simply functional! Just make sure try printing it with best possible layer adhesion. I used some no-name brand PLA but with settings at 5 degrees higher than usual, and it seems to hold water without leak at least for a minute or two, which is perfectly good enough for watering can.
One thing though is that the thin part opens up as you put water close to the top - but I still like the unique esthetic more than anything. (edited)
@iorippi_136497 thanks for the feedback. One thing you could try is set the outer wall to 0.8mm in your slicer. This should make the middle section connect.
Cheers
@nilson_fx Oooh I didn't know such trick! (Obviously I didn't read your short note! Dumb me. Thanks for the note. Hope nobody misses that anymore!)
@HellBz Looks geat. Thanks for sharing.
