Humidity / Temp Sensor Enclosure (Feather S2/S3)

An enclosure to hold a “Feather” prototyping board, with a BME680 or BME688 Temp/Humidity sensor below it.

To secure the board, either hot glue over top of the standoffs, or use a heated flat end of a nail and deform them to more permanently secure the board in place.

I recommend printing the main body of the case in PETG as PLA doesn't seem to have great resiliency in the standoffs (they seem to snap off really easily often)

No supports are needed, print both the cover and base at the same time. Just ensure the cover is printed upside down!