Easy to print and it works great!
Prusa MINI Z-Axis Support Brace
A support brace for the Prusa MINI to stiffen the connection between the Z-axis and the Y carriage.
819
4236
122
31 k
updated
November 7, 2024
Makes
Comments
Thank you for posting your make!
@KoenKooi_31732 Thanks for posting your make.
PETG printed without special tuning. User just need to carefully tighten the screws in position, when Z axis will be safe. Its there only milimeter or less space between Z axis moving parts and this support brace. I was little unsure about this, but gap between parts is still visible. Its also fitting with enclosure use. Thanks!
@Hadriel02_1554665 Looks good! Thanks for posting your photos.
You are welcome!
@AxelDaudet_1333682 Thanks for posting your make!
@Kleckers_592582 Looks great!
@Victor_33439
Sadly it does nit fit in the Mini enclosure because of the fixation of the printer. Ist there a solution so far?
View 5 more comments
@Mattflow_84602 Thanks for posting your make!
@SemiPolaron Thanks for posing your make!
Hi, finished printing in PETG infill 15% and three perimeters as recommended. It seems solid! I'm waiting for you to be able to mount it on my super MINI. Thank you!
@Ivan3D Thanks for posting your make.
Printed on prusa mini in petg. Unfortunately a filament snag caused print failure. Luckily that's never happened again..
@slato_694157 Hope the next print works for you.
@Thmsdc_25233 Thanks for posting your make.
@Timo_1583049 Thanks for posting your make.