UniFi G3 Flex edge mount

I needed an edge mount for my UniFi G3 Flex.
Found nothing fitting.

So I designed my own.
OpenSCAD file included for changes.

And I added my 3mf project file. Inside the 3mf I added some infill modifiers for the holes for better stability.

The four large holes fits for 3,5 x 35 screws.
The two small holes have a diameter of 2mm. You should use selftapping screws here. I uses 2,5 x 10mm screws.

I might add a second version which has unequal cathetus. But you can create it easily with the scad file yourself if needed. For now I am happy with this version I printed.

Print instructions

Printed in PETG with 0.2 settings and 15% infill.

Modifier parts have 100% infill (applies only for .3mf file)

Print time was ~ 3h on my MK3s with 0.2 Quality settings and the above mentioned modifications for the infill.