DIN Rail Mount for MESA 7i96S I/O card for Plasma CNC (v1.0.0)

Note: Several of my designs for my CNC plasma rig are available here for free, and several others are exclusively for my supporters on Patreon that support for any amount, even if only a dollar a month. https://www.patreon.com/design8studio 

This is a DIN Rail Mount for the MESA Electronics 7i96S I/O card for my Plasma CNC based on the LowRider v3 motion system.

• Designed for six M3 screws.
• Print as oriented.
• Prints with no supports.

My intended use for this is for my LowRider v3 CNC plasma table setup. It's basically a LowRider v3 that's tweaked and modified to hold a plasma torch instead of a router. More on that here. You can also read about my router-based LowRider, which was originally built as a v2, and later upgraded to v3.

Note: 

This is a remix of a design by Claus Dieners (February 18, 2022) that I found on GrabCad. His design had side holes, the purpose of which I do not know. Removing them from my remix made it print quicker (15 minutes less print time) and used less plastic (less perimeter walling). If you need a version with the side holes, let me know in the comments or by a direct message. 

Change log:

• November 18, 2022, 7:50 pm (EST): initial posting of v1.0.1.

My PayPal tip jar: https://paypal.me/design8studio  

Various LowRider 3 CNC remixes:

• LowRider 3 CNC Collection

View all my models and remixes on Printables:

• Design8Studio 3D models