Hanger for pipe towel heater/radiator

A super simple and easy to print hanger for your bathroom towel heater/radiator. It will fit radiators with around 20mm pipes and 20mm space between pipes. You just insert the hanger horizontally and twist to upright position.

If your heater gets super hot PLA might not be a right filament yet in my case works well so far.

Print Settings

• Supports: No
• Resolution: 0.2
• Infill: 30%
• Filament: any (if needed go for something more heat resistant like ASA)

If you like my design do not hesitate to visit my YT channel - @taboretum