Sunlu S2 - Caribou Frame Mount

This is a holder for Sunlu S2 Filament Dryer on top of my Caribou Duet 420.

It will be mounted with 3 screws at the frame.

Regarding the print orientation, I ve selected like an orientation like in the attached picture, but you can choose depending on your support settings.

As a Material, for me the best option was ASA. PETG will handle it as well but i would not go for PLA.

The position on top of the frame is technically not the best solution, due its weight way above the center of mass but it is a practical solution, which works fine.

Happy printing :)