Clipped Face Shield

Simple face shield to clip on a cap. Some factories requires to wear a cap and this is remixed to meet this requirement. Maybe, use case of this face shield is non medical field or social manner.
You can assemble without glue. Shield hole size and distance is same as Prusa Face Shield - US version. You can print two components on 150mm x 150mm table one time and it takes about 2 hours.
If you can't open visor dxf by AI, you can try this dxf on this page.

Print instructions

Material: ABS
Layer Height: 0.18mm
Infill: Line 100% without combine
Print Speed: 60mm/s
Raft: Enable
Z direction: Clip needs to be specified Z direction