Z brace frame support CR6 ender 3 Vyper CR10 adapter for lead screw or bars

UPDATE 27/05/2022

Added the other parts of the original file, simplified for faster and easier printing. Added some instructions for the top parts, see image

You need to print:

• z axis brace top right
• z axis brace top left
• z axis brace bottom x2
• z axis brace top 8mm/9mm x2
• z axis brace bottom 8mm/9mm x2

The top right and top left should be printed in a strong filament, with an infill of 100% (can be less, but you want this to be strong). The bottom can have an infill of 25%, but if you do it higher it will be better. The same of the other parts of the brace.

I printed them all at 25% except the top right and top left which I printed at 100% infill

I didnt have 10mm screws, so i used some square nuts. If you have washers, use them.

Just a simple remix for using 8mm and 9mm lead screws or simple circular bars. I recommend the 9mm ones, using a leadscrew. That is the setup i am using right now

The holes are all circular, if you apply some pressure when using lead screws, you will get the holes perfectly for adjusting the parts.

I prefer the leadscrews because they are cheap, easy to get and they are firm. I know i can get a perfect fit and that the adapters will stay in the position i choose.