High standing tablet/smartphone holder, printable on a MINI+

I recently found a nice stand for my iPad by countryskipper, but I had some small issues:

• It didn't fit my Prusa mini at original scale and scaling it down lowered the available space for the iPad.
• It was a bit too unstable for my likings.
• It didn't have a hex pattern (must have right?!)

Highlights for this model

• Hex pattern (of course)
• Props up the tablet 12.5 cm in height
• Wider and bigger foot for optimal stability
• Cutouts at the bottom (10mm diameter) for rubber feet to improve grip.
• New : model available with charging hole

How to print

• Material: Any solid.
  • I used Prusament PLA Marble
• Layer height: 0.20mm
• Perimeters: 2
• Infill: 10% gyroid
• No supports needed
• Brim required.

Support

If you like my effort, give this design a like and share makes!