Gridfinity Container (lightweight)

A parameterized gridfinity container. The pre-meshed models use a 0.6 thick wall, overall making them lightweight without the usage of vase-mode/spiralization.

Features:

• Thick and Thin base (thick base = less space in the container, but no base grid is visible)
• Full length label
• Scooping slide for single slot width thin bottom and any width thick bottom
• Dividers independent of container dimensions (thick and thin bottom compatible)

Mixing the features in various ways should be possible.

A gridfinity spec: https://gridfinity.xyz/specification/

Parametric file:

The features can be enabled/disabled via named features or groups (e.g. “thin base”, “scoop for thick base”, “Divider”).
In case some features show warnings after parameters have been changed, it often is the easiest to “edit” the feature and close it with “ok” without any actual changes. This will force recomputation in Fusion 360.

Printing:

I am using Cura and enabled adaptive layer hight. This will make cross sections between the thin base shells quite nicely printable.