Manta MK2 Rear Mount Universal Plate V1.2 + horizontal low profile cable chain mount

NOTE!

IF YOU ARENT READING THE REST, AT LEAST KNOW YOU NEED SUPPORT STRUCTURES TO PRINT THIS FILE.

Original .STL's:

1. https://www.thingiverse.com/thing:4316238/files (X_axis_hotend_connector.stl) by https://www.thingiverse.com/tobi0892/designs
2. https://www.printables.com/model/169137-manta-mk2-duct-tool-head-system/files (Rear_Mount_Plate_Universal_V1_2.stl) by https://www.printables.com/social/249125-boothyboothy 

• 12-21 gram of material required.
• For my settings 5 hour printing time required (.12mm at 50mm/s)

Reason of remix:

Both parts use the same location of installation, hence these wouldnt fit. Luckily the parts somewhat follow the same general shapes, and were easily combinable.

I like this horizontal cablechain, as its “more quiet” in my experience. And looks more neat. As the cable chain always follows a set restricted path in the cable gutter.

Modifications/effects:

1. Due to the effect of adding the mount on top the top screws are unable to be utilized.  
2. Should not inhibit X, Y or Z movement/build area.
3. Watch out if you use mechanicall Z tramming, make sure your code clears the mount from the Z top endstops.

Settings to print (i printed at):

If you got any questions, or suggestions put them in the comments I'll read them.

This version of the STL, uses stock parts + the parts from the original .stl location. So a 3mm heat insert and M3 hex screw. I reccomend to add washers to all parts to spread the load more due to PETG being a bit more brittle.