Phone holder for Samsung S21 Ultra

This is a phone holder that I designed for my own Samsung S21 Ultra. It is thinned at the back so that a wireless charging plate can be attached if needed.
There is a cutout for the speaker at the bottom. It can also be used lying down. I also thought about the charging cable wire, so there was a cutout for that as well. To prevent the cable from breaking too much, the support part is slightly raised. The camera is also free in a standing position, so you can use it to record video and your two hands are free. I printed it laying on its side, so it needs minimal support.

Nozzle: 0,4
Temp: 205C
Bed temp: 60C
Retract: 4mm/s