SecKit SK Tank parts to mount XChange v1.0 Quick Change w/optional Euclid Probe

This model has a modified master plate to allow SK-Tank belts to be attached.  The plate has holes at bottom right to connect a mount for the Euclid probe. The holes for the probe mount are sized for two M3 thread inserts (optional)

The cap covers the connection for the mounting plates. Provide strain relief for incoming wires and has hole to hold ptfe tube for wire support. On the side it has a mount for the x end stop to be mounted. There is one additional file for a modified X stop finger to allow maximum range for cariage. 

X Stop finger mounts on top of the carbon fiber x gantry. Not sure if it will work with alluminum gantry.

I included all the supports that I used for my models. The Euclide mount prints best upside down with supports on each side for what I found to be the nicest finish where it counts.

The X gantry trigger mounts on left side of cap with two M3 machine screws. I use the machine screws to make threads in the cap holes then back out and mount all parts in place.

All Parts were printed in PC-CF but not strictly nessecary.