Mini Bohrständer drill press

Mini drill press for eMotor with 35mm diameter.

I have used:

2x M8 rods (12 cm) for the stand.
1x M6 screw (70 mm) for the axis.
1x M6 screw (50mm) for the handle.
6x M8 nuts
2x M6 washers
4x M6 nuts
1x 9mm spring

M3 Self-locking Nuts for the case above the motor. M3 Screws 10mm + 12mm + 16mm

The base plate can be screwed on any surface for better stability.

Use loctite or any other glue to fasten the female screws / nuts on the axis. 

Sandpaper the slide a little bit on the wider side, so it slides better. 

The height can be adjusted with the spring base. 

I have used XT60 for power-connection