8bit-mario keychain

Hello everyone! Today I bring to you an 8bit - Mario keychain. This model is printed in pieces and are then glued into the base of the keychain. This keychain has a keyhole that is compatible for hook keychains. The type of glue that I have found to work the best is the Gorilla Clear Grip glue but you may use any other glue that works best for you. below are links to these products. 

The slicer I use is Cura. Here are the settings I use to make the print look better:

Layer height: 0.15

initial layer height: 0.2

wall thickness: 0.8

infill percentage: 100%

Nozzle temp: 205

bed temp 60 degrees

print speed: 35mm/s

support: No

Plate Adhesion: Brim with a line count of 7. Only put a brim on the "mario_base" model to prevent warping. All other attached files do not need special adhesion. 

Make sure to enable ironing on the “mario_base” model for a better finish. 

 Amazon.com: IPXEAD 120PCS Premium Swivel Lanyard Snap Hook with Key Rings, Metal Hooks Keychain Hooks for Lanyard Key Rings Crafting(Silver)

Amazon.com: Gorilla Clear Grip Waterproof Contact Adhesive, 3 Ounce, Clear, (Pack of 2) : Industrial & Scientific