Printhead Cable Support for the Flying Bear Ghost 4

A support for the printhead cable of the Flying Bear Ghost 4 printer. Similar designs exist for the Ghost 4s and the Ghost 5 but they did not seem to work for my Ghost 4 printer…so I created my own.

The support also includes a clip for the bowden tube which can be used in combination with bowden tube holders like this one created by Blinkii.

If printed upside-down, i.e. with the bowden clip on the build plate, no print supports are required.

To mount the support to the head two M3x6 screws can be used. The bore diameter is such that they are self-tapping while being attached.

Print Settings

Printer:

Flying Bear Ghost 4

Rafts:

No

Supports:

No  (print upside-down, i.e. with the bowden clip on the build plate)

Resolution:

0.2 mm

Infill:

20%

Filament:

PLA