Olight Baton II and III lens and charging port cap TPU

TPU covers for the Olight Baton II or III flashlight. This will not work unless it is printed in a flexible material like TPU.

I like to keep my flashlight in my pocket and would like to keep the lens in perfect condition. Also because of the magnet, my flashlight keeps falling on the ground when I take my keys out of my pocket and this will protect it from getting scratched.

To put the cap on for the lens cover you have to stretch the cap loop over the clip as seen in the last photo. The other cap is easier to put on and just slides on the clip from the top.

Print with the cap flat on the print bed and use a support to support the cap loop.