Workstation for Arduino Uno

I created this model to make working with an Arduino & breadboards a bit easier and more organized.  The Arduino should fit exactly, as well as an 830pt & 400pt Breadboards.  The underside is modelled with domed shafts to save some filament and keep the entire model free of the need for supports.

I printed this piece in PETG and did see a nominal amount of shrinkage so I'd recommend printing at 101-102% of scale.   I had printed just the Arduino mount section in PLA and the fit was a perfect snap in place.  The feet I printed in TPU, the feet holes are modelled at 3mm, the feet stems are 3.5mm for a snug fit, but you may need to drill out the holes a bit.

I've added the cable management holes to the right side after I printed it, and will likely make new adjustments like a drawer in the future.