Geometric Plaque Stand

This stand will hold your plaque upright at a slight backwards angle. Its modern, geometric look also provides sturdy support and allows it to fit in anywhere without looking cheap or too DIY.

Any material will work perfectly, choose whatever will fit your space best. The one in my photos is in Sunlu silver PLA.

The back piece is exactly 100mm tall, but can of course support plaques much taller than that. The base slot tapers from 19.7mm down to 19.2, so it will accommodate any plaque thinner than that. Your plaque is leaned back at a 10 degree angle from vertical.

Print at a high layer height to save time, there are no fine details that require a smaller one, so go as high as you can. Any infill will work, 10% is perfect for me. 

Requires no supports, as it easily prints on its side.