No MMU required for this print!
I came up with this idea based on Elod_HU Hive's plan.
Uses a fantastic solution for color printing.
If you are unsure, use pre-sliced gcodes.
What is very important is that Gray is the last color in the print.
After each color change, the nozzle must be thoroughly cleaned and the table inspected to ensure that there are no inapposite pieces in the pattern.
You don't have to worry about the pinda sensor either. Only pay attention to the spilled plastic that can be get stuck in the pattern during bed leveling, it must be carefully removed.
The author marked this model as their own original creation.