Veteran Sherman Trolley Water Cover

This is a remix of  

https://www.thingiverse.com/thing:5408708

I found that the original model had some walls that were too thin (especially when slicing with a 0.6mm nozzle)  

I removed the cloud logo. Made the walls thicker and connected the flaps.

Should be printed with supports, a raft, and out of TPU

After printing the flaps should be cut all the way through with scissors on the perforated line.

Original description 

Veteran Sherman is overall a pretty water resistant wheel which makes it decent for riding in the rain, however one major weak-point is the trolley handle where water will flow directly down into the battery compartment.

The only way to remedy this has been various DIY solutions to cover the trolley handle with a piece of tape, a rain-cover or something similar which will keep water out, that is why I had this idea to design something that solves the problem a bit more permanently so you don't have to carry with, stop and fiddle around with a DIY solution when rain hits.

The idea with this trolley handle cover is for it to sit on the trolley handle more or less permanently, it will sit in place if not removed and will not impair the normal operation of the handle and hopefully offer substantial protection against rain-water. I even put some cute rain clouds on the sides of it to make it's purpose clear as water, isn't that great?

Installation Tip: You can put a piece of tape beneath where the seal clasps the handle to make it say in place even better and overall give a nicer feel when you use the trolley.