2 Piece Face Shield Headband
Description
PDFNot sure if my upload is allowed for this site because I'm not Prusa user.
This is 2 piece face shield headband remix. You can make it by 150mmx150mm build table and can assemble without glue. You can carry over other components from Prusa Face Shield - US version. Surgical Mask Grip by Louis Hitchcock is also remixed to apply small rubber bands.
Due to 2 pieces, the productivity is low. In addition, to get better clip fitting, infill is 100% ABS. It takes about 3 hours for each.
Fine clip engagement will depend on printer accuracy. (I'm not sure if you can get expected accuracy by MINI) And you need post-process like removing burr around clip/mating hole features.
You may need to push hard to engage clips and mating holes.
If you can't open visor dxf by AI, you can try this dxf on this page.
Print instructions
Reference print parameters are
Head Band
Material: ABS
Layer Height: 0.18mm
Infill: Line 100% without combine
Print Speed: 60mm/s
Raft: Enable
Mask Grip
Material: ABS
Layer Height: 0.18mm
Infill: Line 100% without combine
Print Speed: 40mm/s
Raft: Disable
Model origin
The author remixed this model.
